Skip Navigation
This table is used for column layout.



Hull Town Hall
253 Atlantic Ave., Hull, MA 02045

Town Hall Hours
Monday 8:00 AM - 4:30 PM
Tuesday 8:00 AM - 7:30 PM
Wednesday 8:00 AM - 4:30 PM
Thursday 8:00 AM - 4:30 PM
Friday - Closed

Tel: 781-925-2000
Fax: 781-925-0224
 
Fire Safety Alert

WOOD FLOOR SANDERS KILLED WHEN FLOOR FINISHING PRODUCT CATCHES FIRE-MASSACHUSETTS

Wood floor finishing can expose workers, building occupants , and homeowners to fire hazards. In Massachusetts, three wood floor sanders died within a 10 month period (September 2004 - July 2005) in two separate fires when the flammable lacquer floor sealer they were using caught fire. The sealer used in these incidents was highly flammable (flash point 9F-13C).  All three of the fatally injured workers were Vietnamese immigrants.

Incident 1: Two floor sanders died from burns and two were seriously burned while they were refinishing wood floors in a three- family house. The house caught fire while the workers were applying a lacquer sealer that was ignited by a pilot light in a gas stove. At the time of the fire, windows were closed and no other means of ventilation were being used.  

Incident 2: One floor sander died from burns and another received minor burns while finishing wood floors that they installed in a single family house. The house caught fire while the workers were applying a lacquer sealer that was ignited by a pilot light on a gas hot water heater. The heater was located in a closet on the same level of the house where the floors were being finished. At the time of the fire, the front door was open, but windows were closed and no other means of ventilation were being used.

HOW CAN YOU HELP PREVENT FIRE DURING FLOOR FINISHING?

Use less flammable wood floor finishing products (Products with flash points greater than 100F/38C)  for indoor applications.

What is the flash point of a liquid?

The flash point is the lowest temperature at which a liquid produces enough vapor to catch fire the presence of a flame or other ignition source. The lower the flash point, the more flammable the liquid. A product's flash point can be found on the Material Safety Data Sheet (MSDA), or product label or by calling the product manufacturer.

Extinguish all open flames and other ignition sources before beginning work.

diamondbullet.jpgExtinguish gas appliance pilots (on stoves, hot water heaters, heating units, clothes dryers, and other appliances.

diamondbullet.jpgTurn off and unplug cycling electrical appliances (such as refrigerators, air conditioners, heating units, hot water heaters) and other electrical devices.

diamondbullet.jpgDo not light or smoke cigarettes while you are working.

diamondbullet.jpgDo not turn light switches on or off during the floor finishing process, turn off power to work area, if possible.

Adequately ventilate work areas during wood floor finishing.

diamondbullet.jpgOpen windows keep open during product application until  product is dry.

diamondbullet.jpgIf electric fans are used for ventilation, they must be classified as explosion proof and be plugged in outside of the work area.

In addition, employers should:

Provide safety training to employees, as required by law, about the hazards of the chemicals they work with and safe work practices. Training should be provided in the languages spoken by employees.

Conduct a job hazard analysis before each job. Also require employees to complete a safety checklist before each job.

Before starting floor finishing jobs, employers should get information on manufacturer's safety recommendations for all products being used, ignition sources in the house and how to keep the work area ventilated. This information should be part of the safety checklist given to the work crew before going to the work site. Employers should make sure that the safety checklist has been completed before anyone starts work.

This information was obtained from Occupational Health Surveillance Program-Massachusetts Department of Public Health
and the Office of the State Fire Marshal Department of Fire Services